I found this posting on the bay:
http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... 0311698647
Any comments from the experts? I have never seen one of these before.
MAC Forum
For collectors of miniature airplanes of all types. Toys, Models, 'One-of's, Travel Agency models, prototypes, Identification Recognition models, Models assembled from kits.
Drone ID models
Moderator: BWBrown
3 posts
• Page 1 of 1
Drone ID models
by Aeronaut » Fri Jan 28, 2011 10:48 pm
-
Aeronaut - Posts: 203
- Joined: Sat Oct 24, 2009 3:23 pm
- Location: Dallas, Texas
Re: Drone ID models
by grwebster » Fri Jan 28, 2011 10:57 pm
I have seen it on eBay for quite a while now, but know nothing about it. Seller says it is made from white 'pot' metal so who knows, those are too very different materials.
Bronzarts were made from pot metal, but it is a hard and brittle material, the drone is soft so it is white metal, and I don't know any id range that used that material.
Bronzarts were made from pot metal, but it is a hard and brittle material, the drone is soft so it is white metal, and I don't know any id range that used that material.
-
grwebster - Posts: 1779
- Images: 6
- Joined: Fri Oct 09, 2009 5:11 pm
- Location: Central Florida and France
Re: Drone ID models
by grwebster » Sat Jan 29, 2011 4:40 pm
I have a small desk model of a drone, since we are discussing them. Also Have the real propellor for it! For a short time I was based near White Sands and there was an anti aircraft range that flew them.
-
grwebster - Posts: 1779
- Images: 6
- Joined: Fri Oct 09, 2009 5:11 pm
- Location: Central Florida and France
3 posts
• Page 1 of 1
Return to Identification/Recognition Models
Who is online
Users browsing this forum: No registered users and 3 guests